New Rule

Introduction

One of the most important aspect about using our sensors is defining a rule-set for the sensor, and receiving notifications when measured values are outside bound.
This article will show you how to set up a new rule for a sensor within your system.

New Rule

Start by navigating to the "Rules" settings in your navigation menu.

This will open up the rules settings menu.
Start by selecting which system the relevant sensor belongs to.
If rules exists for the selected system, they will display under the 'Rules' tab.
Click on the Create new button to define a rule.

Select a sensor from the dropdown and start configuring!

Unit: A dropdown of SI units available for the selected sensor.
Operator: More than, less than, equal to, not equal to.
Limit: Define a value the sensor must reach for the rule to trigger

Name: Give your rule a descriptive name,
Subscribers: The subscribers dropdown lets you choose accounts to notify when the rule triggers. You can only choose user accounts that is a member of the selected system.
Event message: A message included when subscriber(s) are notified.

Send SMS alerts: When enabled, an SMS will be sent to subscribers of the rule.
Trigger after set time: Lets you define a duration of time the sensor value has to be outside the 'normal' range in order for the rule to trigger.
Limit time of day: Define days and times where the rule should be active.
Duplicate: A dropdown containing sensors that potenially can have the same rule applied. Select from the dropdown if you wish multiple sensors to have this rule.

SMS alerts are very useful for high priority rules.
After you are happy with the new rule, click "Save".

Offline Notifications

Offline notifications for gateway can be selected to get notified if a gateway was offline for more than 30 minutes.
This is very helpful to determine if the Gateway has lost power, need a power reset or have some other issues that prevent it from sending sensor data back to Neuron Cloud.

Alarm Event

When one of your sensors have triggered an alarm, it will change it's tile color to a orange color.
You can then navigate on your right menu into Events where you will find detailed information about the alarm triggered.

Here you will find useful information detailing what triggered the alarm event.

Remove or edit rule

From the rules tab, click the rule you want to remove or edit

From here you can either remove the rule, or save any changes